MAX2982 industrial broadband powerline modem ????????????????????????????????????????????????????????????????? maxim integrated products 1 19-5722; rev 0; 9/11 for related parts and recommended products to use with this part, refer to www.maxim-ic.com/MAX2982.related. general description the MAX2982 powerline transceiver utilizes state-of-the- art cmos design techniques to deliver the highest level of performance, flexibility, and operational temperature range at reduced cost. this highly integrated design combines the media access control (mac) and the phys - ical (phy) layers in a single device. the MAX2982 digital baseband and its companion device, the max2981 analog front-end (afe) with integrated line driver, offer a complete high-speed powerline communication solution fully compliant with homeplug m 1.0 powerline alliance specification. the MAX2982 offers reliable broadband communication for industrial environments. the phy layer comprises an 84-carrier ofdm modulation engine and forward error correcting (fec) blocks. the ofdm engine can modulate the signals in one of four modes of operation: dbpsk, dqpsk (1/2 rate fec), dqpsk (3/4 rate fec), and robo. the MAX2982 offers -1db snr performance in robo mode, a robust mode of operation, to maintain commu - nication over harsh industrial line conditions. additionally, advanced narrow-band interference rejection circuitry provides immunity from jammer signals. the MAX2982 offers extensive flexibility by integrating an arm946e-s? microprocessor allowing feature enhance - ment, worldwide regulatory compliance, and improved testability. optional spectral shaping and notching pro - files provide an unparalleled level of flexibility in system design. additionally, the automatic channel adaptation and interference rejection features of the MAX2982 guar - antee outstanding performance. privacy is provided by a hard-macro des encryption with key management. the MAX2982 supports an ieee ? 802.3 standard media independent interface (mii), reduced media independent interface (rmii), synchronous fifo supporting a glue- free interface to microcontrollers, usb1.1, and 10/100 ethernet mac. these interfaces and standards compli - ance simplify configuration of monitoring and control networks. fast response time and an integrated tempera - ture sensor make the MAX2982 an excellent solution for real-time control over power lines. the MAX2982 operates over the -40 n c to +105 n c temperature range and is avail - able in a 128-pin, lead-free, lqfp package. features s single-chip powerline networking transceiver s homeplug 1.0 compliant s -40 c to +105 c operating temperature range s integrated temperature sensor s up to 14mbps data rate s low-rate adaptation (lora) operation option provides -2db snr performance at 500kbps s 4.49mhz to 20.7mhz frequency band s flexible mac/phy ? field upgradable firmware using tftp ? spectral shaping including bandwidth and notching capability ? programmable preamble ? 128kb internal sram s advanced narrowband interference rejection circuitry s 84-carrier, ofdm-based phy ? automatic channel adaptation ? fec (forward error correction) ? dqpsk, dbpsk modulation ? enhanced robo mode with -1db snr s large bridge table: up to 512 addresses s 56-bit des encryption with key management for secure communication s on-chip communication interfaces ? uart ? 10/100 ethernet ? mii/rmii ? usb1.1 ? high-speed synchronous fifo s aec-q100-rev-g automotive grade qualification applications industrial automation motor control remote monitoring and control building automation broadband over shared coax/copper line homeplug is a registered trademark of homeplug powerline alliance, inc. arm946e-s is a trademark of arm limited. ieee is a registered service mark of the institute of electrical and electronics engineers, inc. ordering information appears at end of data sheet. for pricing, delivery, and ordering information, please contact maxim direct at 1-888-629-4642, or visit maxims website at www.maxim-ic.com. abridged
????????????????????????????????????????????????????????????????? maxim integrated products 2 MAX2982 industrial broadband powerline modem typical application circuit power line ethernet phy phy/mac embedded 802.3 ethernet mac 4-bit rx ethernet connector hpf mac max2981 afe dac lpf/agc adc line driver control 4-bit tx signaling 10-bit data bus signaling control serial bus phy MAX2982 abridged
???????????????????????????????????????????????????????????????? maxim integrated products 33 MAX2982 industrial broadband powerline modem package information for the latest package outline information and land patterns (footprints), go to www.maxim-ic.com/packages. note that a +, #, or - in the package code indicates rohs status only. package drawings may show a different suffix character, but the drawing pertains to the package regardless of rohs status. chip information process: cmos ordering information +denotes a lead(pb)-free/rohs-compliant package. /v denotes an automative-qualified part. part temp range pin-package MAX2982gcd+ -40nc to +105nc 128 lqfp MAX2982gcd/v+ -40nc to +105nc 128 lqfp package type package code outline no. land pattern no. 128 lqfp c128+1 21-0086 90-0143 abridged
|
